Maintenance in Paradise

While we were replacing the cooling system on the trusty diesel, we also researched refrigeration systems. In the end, Engel was what we settled with; three Engels. Their reputation was excellent. Evaporators are the achilles heal. Avoiding puncturing the evaporator the system might last 40 years. Well, that is, some Engels have worked for 40 years in the Australian Woop Woop (the Australian Outback). While not quite equal to the marine environment; it is harsh still.

Once the Perkins Bowman box arrived our boat (home) was knee deep with…stuff. Parts removed from the engine and parts to go on were everywhere. W/ tried to contain all of them under the dining table. The first order of business was to inventory and understand what each part was. Trans Atlantic Diesel has excellent support. With the kit they provided a video of the parts inventory and how to install. Tis always nice to have directions. They were around to answer any question by email. Luckily they only skipped one answer. Remember; this project is in the middle of Covid. Covid is not as bad in Australia as the US. Covid hit the US hard. And I did figure the answer out … eventually . TAD is forgiven. In the end; the words of my cruising brother flash florescent in my head: RTFM. Read the F——, Manual. 🙂

Before actual parts removal was an unwelcome task. And one that I really, really hate – draining the cooling system. We do have an engine sump but still, it is a wet, messy job. I will want to do something about upon rebuild. We drained the coolant, disposed of it at the marina’s waste disposal area and began removing parts.

As in most boat work projects ; when one project begins another one or two show their ugly head. Removing the parts, holding a new part in place to check it out, screamed out to us… PAINT THE ENGINE. Seriously! And the second project was that it is time to replace all the old hoses. Now that we can get to them much easier.

The parts removal went fine. We covered up areas that did not require any paint and took the parts to the recycling business. After all, it is good steel and some copper. There we picked up a few bucks dedicated to a cold one. Every part removed that would be reused, was cleaned and set aside. The engine was much, much smaller now.

We began to clean the engine. First was to hand wash with a degreaser. After which we cleaned with Alcohol and Acetone. Then we applied a primer. The engine changed from mottled Blue, to Grey, and to shinny Blue again. This job was HUGE! Once we painted an area we couldn’t keep working in the engine room. We needed to wait for the primer to dry, then clean another area and paint another part. I wasn’t spraying the beast. I didn’t want overspray getting into the living quarters nor covering any other area of the engine compartment.

At this time we checked the weather to ensure good weather while we were replacing the deck drain hose. One set of hoses had exceeded its working life. It was the cockpit drain. I now have easier access to it. We replaced it at break neck speed. . The next couple of weeks called for cleaning and painting the engine. The majority before putting – re-installing any parts.

Go Slow
Sail Far
Stay Long

Share

Tags: , , , ,

Comments are closed.